Hello, i hope someone can please give me their proffesional opinion, i have 7 broken wires on the rear nearside door. These wires are all at the bottom were the door and pillar meet.
The wires at the door side are all fine they terminate in a sort of a barell assembelly which can be disconnected from the barrel assembelly on the pillar side.
This is were i have the broken wires were they connect to the barrel on the pillar side. can i just strip back the wires and refit them into this barrel assembelly ?? as i have found the barrel difficult if near impossible to open,
or should i buy a new barrel and transfer the wires to that?? or try to strip back what little their is on the wires at the door side and try to solder the wires together. ????
Thank you for your help and advise as i have never done anthing like this before.
Thanks Andrew.
Posted: Jan 2, 2011 (13 years ago)
i had this problem on my car and i had to pull pack the rubber sleeve as far as possible and solder the wires back together,vauxhall do not sell the connector block or terminals seperately,they want you to buy a complete loom,unless you are lucky enough to get a loom from a breakers you will have to repair wires
Posted Jan 2, 2011 (13 years ago)
This problem is archived
If you're having a similar problem please click below to re-post this problem, you can then customise it to suit your situation.