Vauxhall Combo throttle pedal not working and fast ilde with mil lifgt on

Car: Vauxhall Combo
Variant: 1700 dti
Model Year: 2003
Categories: Running Rough, Starting & Power Loss
intermittant fault will drive fine for a while then a shudder and mil light comes on revs go to 1250 rpm and i have no throttle press the brake and the revs drop to 750 if i leave it for a couple of hours i can start again and same happens had it code read and it was saying p1122 low volts from tps to air flow meter changed the tps (throttle pedal) but the fault still remains any help would be greatly appreciated
Posted: Jan 26, 2011 (13 years ago)
Checked the wiring ?
Posted Jan 26, 2011 (13 years ago)
checked wiring all seems fine with wiring and no moisture in plugs
Posted Jan 26, 2011 (13 years ago)
Checked the connection from the throttle position sensor to the ECU ? Also this refers to an Astra pedal but might help to check out .

07-06-2006, 07:47 PM
hi

i have an astra y reg 1.4 16v had emmision light on when i got it, faulty throttle pedal was changed. they said the one sensor on the new peddle that is half the value of the other sensor was fluctuating on idle when it shouldnt. he said it may be the ecu? what do you think?

surely its the pedal sending the readings?

when i picked it up after about 3 miles the engine managment light came on and went into limp mode. started it up again a couple of hours later light was off then after about 10 miles the light came back on.
also it is ex police:bust: and he said they have had some before with ecu problems!

would really appriciate the advice

--------------------------------------------------------------------------------

08-06-2006, 12:00 PM
First things first, check for continuity, short to earth and short to battery on each of the circuits from the pedal position sensor to the ecu. Then do the same for ecu to throttle body. I haven't got the specs. but check the resistance for the two sensors in the pedal, one should go up, one should go down as you press the pedal. check for resistance that don't meet the spec. or values that jump around. After that yoou'll need an OBDII data scanner.....get any Diagnostic trouble codes and check throttle postion sensor values to make sure that engine ecu is seeing throttle at idle and not partial load.

see how you go with these basic check first.


Posted Jan 26, 2011 (13 years ago)

This problem is archived

If you're having a similar problem please click below to re-post this problem, you can then customise it to suit your situation.

Join the community
Got a question? Can you answer other questions here? If so please...
More problems with the 2003 model year Vauxhall Combo

We have 17 problems and solutions in our database for this model year of the car.

View all Vauxhall Combo Problems