Skoda Fabia combi instrument. skoda fabia. code b200049

Car: Skoda Fabia
Variant: 1.0
Model Year: 2017
Categories: Electrics, ECU, Warnings & Lights
combi instrument. Fault flashing up when the car is warm. With abs air bag brake an steering light an epc light after driving on for a few miles all go's back to normal. Had car scanner fault code b200049. Center module fault. Could this be anything other than the instrument cluster fault. The car works fine when driven from cold.
Posted: Jan 4, 2021 (3 years ago)
Think I replied to your post a few months back on this

https://airbagcode.com/skoda-fabia/49

Skoda Fabia, 49 airbag fault code :
This page is about Skoda Fabia air bag problem code 49.


The possible SRS 49 airbag error reason/s;
Internal Electronic Control Module (ECM) fault
Seat Track Position Switch Circuit Fault
Seat Track Position Switch Circuit Resistance Out of Range
Seat Track Position Switch Circuit Short to Ground
#49 Airbag Code Repair order ("Recheck SRS at each replacement.")
Visually check the wiring harness connection.
Replace the harness if it has visible damage.
Replace side air bag module (LH).(Before disposal, it must be deployed.)
Replace the diagnosis sensor unit.
How to disable Skoda Fabia airbag module ?
Remove ash tray from console panel
Using a socket set, remove 4 hex head screws from console panel
Pull console panel out of the two clips
Remove connector from Passenger Airbag Disable module in console panel and take console panel to a work bench
Remove 2 phillips head screws to remove the airbag key module
Carefully unclip the plastic tabs that hold the airbag key module case together
Remove circuit board from airbag key module housing
To prepare the module housing I drilled a 1/4" hole through the clear lens allowing my particular LED to be attached through that hole
Now carefully unsolder the blown light bulb
Then you are able to solder on the new LED *polarity matters* with that in mind the negative on the circuit board is closest to the outer edge of the circuit board
Reassemble the PAD Module and put it back into the console panel and then put everything back together on the dash in the reverse order of removal.


Airbag In Car
How to clear Skoda Fabia 49 airbag code ?
Follow the diagnostic procedures to service the fault condition flashing on the air bag indicator prior to code clearing.
Cycle the ignition switch to OFF and then to RUN.
Observe air bag indicator prove-out (six ? two seconds) followed by diagnostic trouble code (52-85) flashing completely one time.
Locate the Diagnostic "Trouble Code Clear" Connector (grey connector). located underneath the glove compartment, left side (06010) containing Circuits 631 (T/R) and 57 (BK).
Use a jumper wire to short Circuit 631 (T/R) to Circuit 57 (BK) or to another good ground. This short must be made after the diagnostic trouble code flashes completely one time, but before the warning light stays on continuously.
Hold short until air bag diagnostic monitor tone sounds (approximately five seconds).
Release short on Circuit 631 (T/R) to Circuit 57 (BK). This short must be released within 25 seconds after the diagnostic monitor tone sounds.
Diagnostic trouble code is now cleared from memory.
Posted Jan 4, 2021 (3 years ago)
As a follow up to the fault code b200049. The car was scanned at my local garage and diagnosed a faulty instrument cluster.
Posted Oct 22, 2021 (3 years ago)
9 months to solve and fix ????
Posted Oct 22, 2021 (3 years ago)

This problem is archived

If you're having a similar problem please click below to re-post this problem, you can then customise it to suit your situation.

Join the community
Got a question? Can you answer other questions here? If so please...
More problems with the 2017 model year Skoda Fabia

We have 3 problems and solutions in our database for this model year of the car.

View all Skoda Fabia Problems