Peugeot 206 loud noise without car even running

Surely it's got to be the alarm that's been activated ??

is noise coming from inside the car?

Not really sure where the noise is coming from. It sounds louder outside the car than in it though. Not sure if it's coming from in the bonnet because it sounds equally as loud with the bonnet up or down.

There's definitely no alarm on the car. I've asked the salesman and he assures me there are only alarms on the highest spec cars. I bought the car from my dad who originally bought it new so I know the car has not been modified in any way.

it probably is the horn going off. you need a new one

I've managed to identify the cause of the original problem after phoning a technician in the local Peugeot garage. After removing the fuse for the horn the noise stopped so thank you for your help.

Since then the car does not start. The battery symbol has appeared on the dash but I have checked the connections and they are all tight - no visible problems.

Also now the key fob does not work even with a new batter and the central locking system does not work. A neighbour who has been helping me thinks the local Peugeot garage have not reset something after connecting the car to the computer to reset the service reminder. I hate my local Peugeot garage - this is the second time I've had problems after taking my car there to be serviced!!

Any ideas what this could be please?

If removing the fuse stopped the horn going off then as said before i suspect the horn is faulty. the fuse you removed must also be used for other things if not now working.I think you will find it is a coincidence this happened since it was serviced.there may be other causes but i would try a horn first.

Could try disconnecting horn , refitting fuse and then reprogramme key fob ?


PEUGEOT 206 PLIP - Remote Key Programming



CENTRAL DOOR LOCK (1 BUTTON PLIP KEY)

1. Ensure all the doors are unlocked using the key.

2. Press and hold the plip key button until the LED stops flashing.

3. After releasing the button, the LED will light constantly.

4. Press the Plip Button once, and the LED will extinguish.

5. Open the door and hold the Plip key near the Ignition switch, and press the plip button one time.

6. Turn the ignition ON, and wait 10 seconds, then turn ignition OFF.

7. After 5 seconds the Plip should now operate.

CENTRAL DOOR LOCK with DEADLOCKING (2 BUTTON PLIP KEY)

1. Ensure all doors are unlocked using the key.

2. Press and HOLD the large plip key button while the LED flashes continuously for 20 seconds. After 20 seconds press the small deadlock button once while still holding the large button.

3. The LED will stop flashing.

4. Release the large button and the LED will light constantly.

5. Press the large button once and the LED will go out.

6. Open the door and hold the Plip key near the Ignition switch and press the large plip button once.

7. Turn the ignition ON, wait 10 seconds and then turn the ignition OFF.

8. After 5 seconds the Plip should now operate.


206 PLIP PROGRAMMING SYNCHRONISATION—BSI

1. Insert the Ignition Key.

2. Press the small Black button.

3. Switch the Ignition ON

4. Keep the lock button pressed for 10 seconds.

5. Release lock button , switch ignition OFF and remove key.

6. Close all doors and press the lock button 2 times.

NOTE : If PLIPS still do not work, start the vehicle and then turn OFF. Open and close the door, and check PLIP again.