Ford Fiesta hazard lights

check all the door lock motors are working ok and that door pin switches are not broken,could be that the PATS module is seeing a fault somewhere and not activating the alarm correctly,get a diagnostic done on IDS

Assume from what you say car is locking o.k and it is just the hazards that are not working .Almost sure there are no door pin switches on your car , only micro switches in door locks / boot lock .Have you tried the hazard switch in car to see if it is working o.k .This tells you how to reprogramme the remote if you want to try that .






Re: 2005 fiesta remote
Reply #2 - 25.05.09 at 23:25:43
Remote Transmitter Programming Fiesta 2002.25 (11/2001-09/2008)




1.

NOTE: A maximum of four remote transmitters can be programmed to the generic electronic module (GEM). Programming must be done at the same time for all the transmitters.

NOTE: To enter programming mode, first make sure that the vehicle battery is fully charged and the anti-theft system is not armed or triggered (if equipped).
Close all doors to make sure conflicting chimes do not sound during programming.



2.
Turn the ignition switch from position I to position II four times in six seconds.



3.
Turn the ignition switch to position 0.



4.
A chime sounds to indicate that the GEM is in the learning mode and it is possible to program remote transmitters.



5.
Press and hold one of the buttons on the remote transmitter until a chime sounds. This indicates a new transmitter code has been successfully received.



6.
After each successful programming, another 10 second learning mode is automatically entered, up to a maximum of four times.



7.
To program additional remote transmitters, repeat step 5.



8.
The system will leave the learning mode after the ignition switch is turned to position III, or if no new transmitter is programmed during the 10 seconds, or if four remote transmitters have been programmed.



9.

NOTE: An incorrect programming procedure does not affect the stored codes.
After successful programming, only the new programmed transmitters will be accepted.



10.
Test all the programmed transmitters, by activating and deactivating the locking/unlocking functions.